Owner's Manual

5. The large Gas Line Nut (17) ts into the recessed area as shown. Tighten the small Gas

Line nut with your ngers.

6. After the marker is completely reassembled, tighten the nut with a wrench.

Further Reassembly

Numbers in parentheses refer to parts diagram item numbers. Apply Tippmann Certied

Marker Oil to parts marked with an asterisk* prior to

reassembly.

1. Install the four Trigger Pins (4).Install the black Sear

Pin (5). Install two Linkage Arm Pins* (6) shown in

Figure 15.

2. Place the Trigger (9) onto the Trigger Pins. Install

the yellow Trigger Spring (10). Make sure the Trigger

Guard (12) is in place.

3. Refer to Figure 12 and install the Front Bolt* (21)

and then the Rear Bolt* (49).Rotate the Front and

Rear Bolt so that the holes for the Linkage Arm are

accessible. Insert the Linkage Arm* (ACT #50, non-ACT #51) into the holes and rotate

so that the Linkage Arm is between the Pins (6).

4. Place the Sear (7) onto the Sear Pin. Install the green Sear Spring (8) as shown in

Figure 15.

5. For ACT markers, refer to the Parts Diagram on pages 18-19, and install the Spring

Cup* (51), Upper Spring Long* (53), Spring Pin* (54), making sure the longer end of the

Spring Pin goes into the Rear Bolt. Install the Upper Spring Short* (55). Install the Bolt

Handle (47), Drive Spring* (52) and Guide Pin* (48), Buffer O-Ring (56), and the End

Cap (31).

6. For non-ACT markers, refer to the Parts Diagram on pages 24-25, and install the Rear

Bolt Plug (non-ACT #50, ACT markers do not have a rear bolt plug), the Bolt Handle

(47), Drive Spring* (52) and Guide Pin* (48), Buffer O-Ring (56), and the End Cap (31).

7. If previously removed, reinstall the two Air Supply Adapter Nuts (13).

8. Set the Left Front Receiver half (23) onto the marker. Install and tighten one receiver

screw (26).

9. Install the Front Grip (25). Secure with one long receiver screw (27).

10. Place the Left Rear Receiver half (32) onto the marker. Insert ve Receiver Screws (24)

and fasten nger-tight. For ease of installation, tighten the bolt over the Trigger rst.

Tighten all Receiver Screws using the included allen wrench.

11. Attach the Air Supply Adapter (35) with two screws (36 and 37). NOTE: The short ASA

screw (36) goes in front.

12. Apply Tippmann Certied Marker Oil onto the Barrel O-Ring* (39), insert the Barrel (38)

and carefully screw it in.

13. Slide the Feed Elbow (40) pins into the Right Receiver Half bosses and rotate up until

the Front Sight (19) holds it in place.

Pages 18 through 28 show parts diagrams and parts lists for the 98 Custom PS markers.

Figure 15:

Trigger and Sear Detail