User Manual

Unloading Your Marker

1. Eye protection designed for paintball use must be worn by the user and any person

within range.

2. Empty and remove the hopper.

3. Go to a designated ring area, remove the barrel sleeve and turn off trigger safety.

4. Point your marker in a safe direction and re several times to be sure there are no

paintballs lodged in the chamber or barrel. Visually inspect the chamber for paintballs.

5. Return the trigger safety to the Safe mode (see page 6). Reinstall the barrel sleeve (see

page 4).

Air Supply Cylinder Warnings

WARNING

The brass or nickel plated cylinder valve (Figure 3, #1)

is intended to be permanently attached to the air or CO

cylinder (2).

An air or CO

cylinder can y off with enough force to cause

serious injury or death if the cylinder (2) unscrews from a

cylinder valve (1).

Refer to Figure 3. There have been reported incidents caused

by players unknowingly unscrewing the cylinder (2) from the

cylinder valve (1). This occurs when the player thinks the

entire valve-cylinder assembly is being unscrewed from the

air supply adaptor of the paintball marker, when in fact they

are unscrewing the cylinder from the cylinder valve.

To avoid this danger, it is recommended (if your cylinder is

not already marked) that you use paint or nail polish to place

a mark (3) on the cylinder valve, and place another mark (4)

on the cylinder, in line with the #3 mark as shown.

Whenever you turn the cylinder during removal, watch the

marks on the cylinder and the cylinder valve to be sure

that they rotate together. If at any time these marks start

to separate as shown in Figure 4, the cylinder is starting to

unscrew from the cylinder valve and you must STOP and

take the entire unit to a “C5” certied airsmith for safe removal

and/or repair.

NOTE: The cylinder valve should unscrew from the paintball

marker in about 3 or 4 full turns. If you nish the 4

full turn

and the cylinder valve is not unscrewed from the paintball

marker, STOP! Take the entire unit to a “C5” certied

airsmith for safe removal and/or repair.

Locate a “C5” Certied Airsmith at www.paintball-pti.com/

search.asp.

Figure 3: Marked Cylinder and

Valve

Figure 4: Misaligned Cylinder

and Valve