User Manual

17
E
N
G
L
I
S
H
Valve Removal
• Do not disassemble this marker while it is pressurized.
• Do not pressurize a partially assembled marker.
1. Unscrew the rear end cap by inserting an allen wrench through the hole in the end cap
and turning counter clockwise.
2. Remove the end cap and then pull the spring out.
3. Field strip the marker (see Field Disassembly on page 13) which allows you access
from the front of the receiver to push the valve out through the rear end cap opening.
Valve Installation
1. Inspect the O-rings.
2. Lubricate them with a light coat of oil or Molykote
®
33 before re-assembly to avoid
O-ring damage.
3. Insert the valve into the rear of the receiver (valve tube rst).
4. Lightly coat the end cap O-ring with a light oil or Molykote
®
33 to eliminate pinching the
O-ring.
5. Insert the valve spring and then turn the end cap into place by hand.
6. Using an allen wrench, tighten the end cap.
Figure 10: Valve Assembly, Spring, and End Cap
Valve Tube end of the Valve Assembly Valve Spring End Cap