Data Sheet

www.tinysine.com
A. Send AT command configuration module.
B. Collect PIO04 to the PIO11 pins input state of HM-10.
C. Collect PIO03 pins input state of HM-11.
D. Remote control PIO2, PIO3 pins output state of HM-10.
E. Remote control PIO2 pin output state of HM-11.
F. Send data to module UART port (not include any AT command and per
package must less than 20 bytes).
Mode 2:
Before establishing a connection, you can use the AT command configuration module
through UART.
After established a connection, you can send data to remote side. Remote
side can do fellows:
A. Send AT command configuration module.
B. Remote control PIO2 to PIO11 pins output state of HM-10.
C. Remote control PIO2, PIO3 pins output state of HM-11.
D. Send data to module UART port (not include any AT command and per
package must less than 20 bytes).
46. Query/Set Notify information
Send
Receive
Parameter
AT+NOTI?
OK+Get:[para]
para: 0, 1
0: Don’t Notify
1: Notify
Default: 0
AT+NOTI[para]
OK+Set:[para]
If this value is set to 1, when link ESTABLISHED or LOSTED, module will send
OK+CONN or OK+LOST string through UART.
47. Query/Set Notify mode
Send
Receive
Parameter
AT+NOTP?
OK+Get:[para]
para:0, 1
0: Without address
1: With address
Default: 0
AT+NOTP[para]
OK+Set:[para]
Added since V534 version.
If this value is set to 1, when module is connected to remote device, UART will send
“OK+CONN:001122334455”, “001122334455” is central role’s mac address.