Product Overview

If the block is green, the two TinyShields can be used together on the same stack with no issues

If the block is orange, then see the note below for the special conditions

If the block is red, the two boards cannot be used together.

Note 1: Two Bluetooth LE Modules can be used, however one must have the hardware resistors changed to use pins 0 and 1 for the UART

Note 2: Motor 1 cannot be used with a Bluetooth LE Rev 2 board, unless the hardware resistors are changed to use pins 0 and 1 for the UART

Note 3: Motor 1 and Motor 4 channels cannot be used with the WiFi or Nordic BLE TinyShields

Note 4: Only Motor 1 channel can be used at the same time as the 16 and Circle Edge LED TinyShield

Note 5: Multiple Edge LED boards can be plugged together, however they will all show the exact same pattern

Note 6: 9 Axis I2C address must be changed using the address resistors

Note 7: Two TinyShields can be used at the same time if the address resistors are changed on one of the boards

Note 8: The Bluetooth LE TinyShield must have the hardware resistors changed to use pins 0 and 1 for the UART

Note 9: Only Motor 3 & 4 channels can be used with the Audio TinyShield is used

Note 10: Nordic BLE board requires the interrupt resistor to be switched to R3 position

Note 11: Motor 1 and Motor 3 channels cannot be used with the SI4432 433 MHz TinyShield

Note 12: TinyScreen I2C address must be changed using the address resistor

Note 13: Servo driver reset line(R6) must be cut for full compatibility

Note 14: Nordic BLE and servo driver share IO9 for reset, software workaround is easy, or see note 13

C O M PA N Y

About TinyCircuits

Distributors

H E L P

Customer Service

Terms & Conditions

A B O U T T I N Y C I R C U I T S

TinyCircuits is a Maker of Tiny Open Source

Electronics that are easy to use and let you

create miniature electronic projects.

N E W S & U P D AT E S

releases and more …

Enter your email address...