Users Manual Part 2

14
Status Reminder
Connect to the
appliance
Please download Tineco
app and connect the
PURE ONE
WiFi network
connected
Network connected
WiFi network
disconnected
Disconnected
Voice prompts on Voice prompts on
Voice prompts
disabled
Voice prompts disabled
Restore factory
settings
Factory settings restored
AUTO mode by
default
AUTO Mode
Switch to Manual
mode
Manual Mode
Switch to MAX mode MAX Mode
Low battery
Battery level is below
20%
No battery, please
charge
Battery level is at 0,
please charge the
appliance
Brush roller is
tangled
Brush roller tangled,
please clean the brush
Dust sensor
malfunction
Dust sensor malfunction,
please clean the dust on
the inner sensor
Air channel blocked
Air channel blocked,
please clean the air
channel and dustbin
Power is off Power off
Start charging Charging
Help Center
Cleaning tutorial
Voice switch
Network conguration
Restore factory settings
Exit
MAINTENANCE
Note:
• Clean the dustbin and lters after each use.
• To maintain high performance, wash and dry
the pre-lter monthly, replacing it every 6
months. Wash and dry the HEPA lter every 3
months, replacing it every 12 months.
Dustbin, Mesh Filter and
Pre-lter
1.Turn counter-clockwise to remove the lters.
Fig.E-1
2.Do not turn the appliance upside down when
removing or installing the lter to prevent dust
from entering the motor.
Fig.E-2
3.Clean the dustbin and mesh lter with a damp
cloth or the cleaning tool. Air dry completely
before reinstalling.
Fig.E-3
4.The pre-lter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-4
5.After cleaning, insert the pre-lter into the
mesh lter properly and it clicks into place.
Install the clean lters back into the main body,
then close the dustbin ap.
Fig.E-5
HEPA Filter
1.Pull out the HEPA lter (in magnetic design) for
cleaning. Do not use the appliance without rst
installing the HEPA lter.
Fig.E-6
2.The HEPA lter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-7
Dust Sensor
• To avoid dust accumulation which can affect
cleaning performance, wipe the suction mouth
with a damp cloth.
Fig.E-8