Users Manual Part 2

12
• Press the release button to remove the tube.
Fig.C-3
Brush Installation
• Insert the power brush.
Fig.C-4
• Press the release button to remove the power
brush.
Fig.C-5
Battery Installation
• Press the battery release button, and remove
the battery.
Fig.C-6
• To install, slide the battery into the slot at the
base of the main body. The battery will click
into position when correctly tted.
Fig.C-7
Charging Dock Installation
• Lift up the charging post to the upright
position.
Fig.C-8
• Press hard to x the charging post rmly on the
dock.
Fig.C-9
• For easy storage, pull up the charging post and
then press down.
Fig.C-10
OPERATION
Preparing for Use
Note:
• Before the rst use, please charge the
appliance (see “Charging the Battery”) for
3-4 hours in an area where the ambient
temperature is between 39.2°F (4°C) and 104°F
(40°C).
• Select an accessory and attach it to the
appliance before use (see “Accessories”).
1.Press the
button to activate the suction.
Press it again to turn off the appliance.
Fig.D-1
2.The appliance will start in AUTO mode by
default. Press the
button to switch between
AUTO and MAX mode. Swipe the power
control slider to switch to Manual mode.
Fig.D-2
3.Place the appliance and attachments on the
charging dock for convenient storage after use.
Fig.D-3
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor automatically
detects how dirty the surface is and applies the
appropriate suction power.
• A red dust monitoring loop indicates more dust
is detected whereas a blue loop indicates less
is detected. This mode automatically provides
the best cleaning solution.
Fig.D-4
MAX Mode
• In AUTO mode, press the button to enter
MAX mode.
• In MAX mode, the iLoop only displays the dirty
amount, and the suction power keeps at the
maximum.
Fig.D-5
Manual Mode
• In AUTO or MAX mode, swipe the power
control slider to switch to Manual mode.
• In Manual mode, you can control the power as
needed.
Fig.D-6
Note:
• Keep sharp objects away from the digital
display screen to avoid scratches and scrapes.
• Only use with dry hands. Dirty hands may affect
slider operation.
Emptying the Dustbin
1.With the power off, push down the dust empty
tab to clean the dustbin. If too much dust
causes a blockage, press the release button on
the dustbin and empty the contents.
Fig.D-7