Users Manual Part 2

EN
14
2.After removing the brush roller, gently clean
the brush window, suction mouth and the row
of plastic teeth.
Fig.E-14
3.Fully reinsert the brush roller into the brush
window and the end cover can be rotated
clockwise until it clicks securely back into place.
Fig.E-15
Warning:
• The power brush contains electrical
components which must not be soaked or
washed with water.
• Turn the power off and remove the battery before
performing maintenance for the brush roller.
• To reduce the injury, do not touch the brush
roller while the appliance is in working condition.
TROUBLESHOOTING
Problem Solution
The appliance does
not turn on
Charge the battery
Restart after cooling
down
Check and remove
blockages
Weak suction power
Clean the dustbin and
lters
Install the pre-lter
Remove blockages
Clean the brush roller
Abnormal sounds or
plastic teeth tangled
in brush
Pull out the brush roller
and remove blockages
Suction mouth blocked
Remove the mesh
lter, clean the suction
mouth and dustbin
4.The pre-lter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-4
5.After cleaning, insert the pre-lter into the
mesh lter properly and it clicks into place.
Install the clean lters back into the main body,
then close the dustbin ap.
Fig.E-5
HEPA Filter
1.Pull out the HEPA lter (in magnetic design) for
cleaning. Do not use the appliance without rst
installing the HEPA lter.
Fig.E-6
2.The HEPA lter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-7
Dust Sensor
• To avoid dust accumulation which can affect
cleaning performance, wipe the suction mouth
with a damp cloth.
Fig.E-8
Mini Power Brush
1.Press against the roller end cover downward.
Fig.E-9
2.Pull out the brush roller.
Fig.E-10
3.Remove the debris wrapped around the roller
with the Tineco Hair Cleaning Tool.
Fig.E-11
4.Fully reinsert the brush roller at an angle and
push upward until it clicks securely back into
place.
Fig.E-12
Brush Head
1.With the power off, slide the switch to open
the brush roller end cover, and rotate it
counter-clockwise to pull out the brush roller.
Fig.E-13