Users Manual Part 2

EN
13
Indicator
For any of the following notications, consult the
“Troubleshooting” section of this manual.
When in Use
Battery level > 20%:
solid green light.
Battery level ≤ 20%:
solid red light.
Blinking red light: fault.
Blinking: brush roller has a
blockage.
Blinking: appliance has a
blockage, either in the lter or
the dustbin.
Blinking: sensor inside the
dustbin is obstructed, or
the dustbin is not correctly
installed.
Blinking: motor failure.
Illuminated: WiFi has
successfully connected.
Blinking: WiFi is connecting.
Off: WiFi is not connected,
please connect.
During Charging
Charging (Battery 0-99%)
Battery icon: solid green.
Battery indicator: blinking green.
Tineco indicator: blinking.
Fully charged (Battery 100%)
In 5 mins
Battery icon & Battery
indicator: solid green.
Tineco indicator: illuminated.
After 5 minutes: all indicator
lights turn off.
Battery icon blinking green:
No battery pack or battery
pack installed incorrectly.
Both blinking red: fault.
MAINTENANCE
Note:
• Clean the dustbin and lters after each use.
• To maintain high performance, wash and dry
the pre-lter monthly, replacing it every 6
months. Wash and dry the HEPA lter every 3
months, replacing it every 12 months.
Dustbin, Mesh Filter and
Pre-lter
1.Turn counter-clockwise to remove the lters.
Fig.E-1
2.Do not turn the appliance upside down when
removing or installing the lter to prevent dust
from entering the motor.
Fig.E-2
3.Clean the dustbin and mesh lter with a damp
cloth or the cleaning tool. Air dry completely
before reinstalling.
Fig.E-3