Users Manual Part 2

EN
11
6. Flexible long crevice tool
Easy to bend, easy to reach tight spots.
Suitable for cleaning dust behind and beneath
furniture, around refrigerators, and many other
tight gaps.
7. Multi-angle folding tube
An articulated joint makes it adjustable to allow
for exibility when cleaning from high to low.
8. Flexible extension hose
Excellent extension and exibility to access
hard-to-reach spaces; perfect for in-care use.
Compatible with all non-motorized Tineco
accessories.
9. Hair cleaning tool
Use the end with the small blade to remove
hair and debris wrapped around the roller.
Use the end with the brush to clean the brush
window, and the dustbin, as required.
Fig.B
ASSEMBLY
Tube Installation
• Insert tube.
Fig.C-1
• Insert to the main body.
Fig.C-2
• Press the release button to remove the tube.
Fig.C-3
Brush Installation
• Insert the power brush.
Fig.C-4
• Press the release button to remove the power
brush.
Fig.C-5
Battery Installation
• Press the battery release button, and remove
the battery.
Fig.C-6
• To install, slide the battery into the slot at the
base of the main body. The battery will click
into position when correctly tted.
Fig.C-7
Charging Dock Installation
• Lift up the charging post to the upright
position.
Fig.C-8
• Press hard to x the charging post rmly on the
dock.
Fig.C-9
• For easy storage, pull up the charging post and
then press down.
Fig.C-10
OPERATION
Preparing for Use
Note:
• Before the rst use, please charge the
appliance (see “Charging the Battery”) for
3-4 hours in an area where the ambient
temperature is between 39.2°F (4°C) and 104°F
(40°C).
• Select an accessory and attach it to the
appliance before use (see “Accessories”).
1.Press the button to activate the suction.
Press it again to turn off the appliance.
Fig.D-1
2.The appliance will start in AUTO mode by
default. Press the
AUTO
MAX
button to switch between
AUTO and MAX mode.
Fig.D-2
3.Place the appliance and attachments on the
charging dock for convenient storage after use.
Fig.D-3
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the power indicator and
the color of dust monitoring loop change
according to the amount of dust detected.