FLOOR ONE S5 PRO 2 SERIES Smart Cordless Vacuum & Washer Instruction Manual Manual De Uso Mode D’emploi *Actual product may differ from illustration. TINECO IS HERE TO HELP. We’ll get back to you within 1 business day. www.tineco.
EN CONTENTS Important Safety Instructions................................................................ 2 Specifications......................................................................................... 6 Overview................................................................................................. 7 Accessories............................................................................................ 8 Assembly...........................................................................
EN Important Safety Instructions SAVE THESE INSTRUCTIONS Household use only. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE). Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING – To reduce the risk of fire, electric shock, or injury: 1.
3 EN 16. Recharge only with the charger specified by Tineco. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. 17. Use appliances only with specifically designated Tineco battery packs. Use of any other battery packs may create a risk of injury and fire. 18. Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water.
EN 38. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces. 39. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. Range of Usage 1. The cordless hard floor cleaner is to be used on indoor hard floors, such as vinyl, tile, sealed wood, etc. Use on a rough surface may not get the best performance. 2.
TINECO INTELLIGENT, INC. 1700 WESTLAKE AVENUE N., SUITE 200, SEATTLE, WA, 98109, USA WWW.TINECO.COM 1-855-292-8864 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and find it to comply with the limits for a Class B digital appliance, pursuant to Part 15 of the FCC Rules.
EN (2) T his appliance must accept any interference, including interference that may cause undesired operation of the appliance. - This Class B digital apparatus complies with Canadian ICES-003. - This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
EN Overview A O B C P I Q J D K R L M S E F G T H N A. Self-cleaning Button K. Clean Water Tank Release B. AUTO/MAX/ULTRA/SUCTION Mode L. Clean Water Tank Handle C. Power On/Off M. Clean Water Tank (CWT) D. Digital Display N. Brush Roller E. Dirty Water Tank Release O. Deodorizing & Cleaning Solution F. Dirty Water Tank Handle P. Cleaning Tool G. Dirty Water Tank (DWT) Q. Dry Filter & Holder H. Brush Roller Cover R. Accessory Holder I. Tube S. Adaptor J.
EN Accessories Note: Accessories may vary between markets. If you require more accessories, please go to www.tineco.com or store.tineco.com. Deodorizing & Cleaning Solution Removes dirt, grime, grease and tough stains from most types of hard surfaces, like tile, marble, sealed hardwood floors, and more. Always use Tineco solution in your appliance. Add one bottle cap of solution to each full tank of clean water. Brush Roller Soft roller head with bristles can be used to vacuum and wash at the same time.
Assembly EN How to Assemble/Disassemble Note: For water tank and brush assembly, please refer to “Operation” and “Maintenance”. click To assemble the handle, insert it into the appliance until you hear a click. In the event that the handle need to be disassembled, press the spring to release the handle with a tool (like a screwdriver) and lift the released handle from the appliance. Tips: WiFi/Mute/Language Switch Button • Press to turn on/off the voice prompt. • Press twice to switch languages.
EN Operation Preparing for Use Before first use, please charge the appliance for 4-5 hours (refer to “Charging Instructions” for details). * Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C). Tips: (SUCTION mode not available) • Solution mode/Water Only mode: Appliance starts with Solution mode by default. Power on while the appliance is upright, long-press for 3s to switch between the two modes.
MAX Press the Clean Water Tank release button to remove it from the appliance. Open the tank cap, and fill with tap water to the Max line. When deep cleaning is necessary, add one bottle cap of solution to the CWT and tightly close the cap. Note: Only use water under 140°F/60°C. DO NOT USE HOT WATER. ② click ① Place the tank back into the appliance. You should hear a “Click” if done correctly.
EN Digital Display • An updated display shows everything with interactive animation. giving you a brand new experience during and after cleaning. Note: Keep sharp objects away from the digital display screen to avoid scratches and scrapes. Cleaning Mode Selection AUTO Mode • In AUTO mode, the iLoop sensor automatically detects how dirty the floor is and applies the appropriate amount of detergent and suction power.
• In ULTRA mode, press the button to enter SUCTION mode. • In SUCTION mode, the appliance will only absorb water and do not spray. We recommend using this mode on the wet surface. Runtime • In AUTO/ULTRA/SUCTION mode: ~35minutes • In MAX mode: ~28minutes • Estimated runtime data was obtained by a Tineco Laboratory. Charging Time • A full charge takes approximately 4-5 hours. • Estimated data was obtained by a Tineco Laboratory using ambient temperatures between 39.2°F (4°C) to 104°F (40°C).
EN Voice Prompt (Contents may vary, please in kind prevail.
Note: • For optimal performance and to prevent odors, always clean and dry DWT, filters, brush roller, brush roller cover completely after each use. • Please make sure each part is installed correctly or the appliance may not work properly. • After maintenance, place the appliance on the charging base vertically. Do not expose the appliance to direct sunlight, and store it indoors in a dry place. Main Body To reduce the risk of injury, switch off before performing maintenance.
EN Dirty Water Tank click • When dirty water reaches the Max line, the appliance will stop working and show a reminder on the display and play a voice prompt. • Pull up the tank lid to empty the DWT. Use the cleaning tool to remove remaining debris. Rinse the inside of the DWT and place back into the appliance. Dirty Water Tank Lid If the Dirty Water Tank lid and the filter inside have been blocked, remove the tank lid and the filter, rinse both parts with water.
1. Place the appliance on the charging base after use, the sensor will auto-detect the level of dirt. 2. When you hear the voice prompt “please begin selfcleaning cycle,” press the self-cleaning button and begin the process. 3. Once complete, you will hear the voice prompt “selfcleaning completed, please clean the Dirty Water Tank.” At this point, the appliance will begin charging. Note: • Ensure the charging base is plugged in and the battery level is >10%.
EN Brush Roller Remove the brush roller by grabbing the brush roller tab and pulling out. Using the cleaning tool, remove the hair and debris wrapped around the roller and rinse with water. Replace the brush roller back into the accessory holder, and allow it to dry completely before reinstalling. Remove hair and debris from the brush roller chamber and the opening with a tissue or a damp cloth.
Problem Possible cause Solution The appliance does not turn on Auto protection for overheating Restart after cooling down Weak suction The dry filter is not installed, or the dry filter is dirty Install the dry filter or clean and allow it to dry completely Brush roller tangled in animation Voice prompt: 1. The brush roller is blocked 2. The brush roller is not 1. Please clean the brush roller 2. Please install the brush roller installed correctly 1. Remove blockages 2.
EN Warranty 2-YEAR LIMITED WARRANTY • Only applies to purchases made from authorized retailers of Tineco. • Is subject to the adherence of the requirements outlined in this instruction manual, and is subject to further conditions outlined below. • This warranty is governed by and construed under the laws of the country in which the purchase took place. We provide 2-year warranty or a warranty period as stipulated by applicable local law, whichever is longer.
• Any implied warranties relating to your appliance including but not limited to warranty of merchantability or warranty of fitness for a particular purpose, are limited to the duration of this warranty. • Warranty coverage applies to the original owner and to the original battery only and is not transferable. • This limited warranty gives you specific legal rights. You may also have other rights which vary by region.
FR SOMMAIRE Consignes de sécurité importantes................................................... 45 Spécifications....................................................................................... 50 Description........................................................................................... 51 Accessoires........................................................................................... 52 Assemblage....................................................................................
Consignes de sécurité importantes CONSERVEZ CES INSTRUCTIONS Usage domestique exclusivement. AVERTISSEMENT – Afin de réduire le risque d’incendie, de décharge électrique ou de blessures corporelles : 1.
FR 12. Ne passez en aucun cas l’aspirateur sur des objets brûlants ou incandescents, comme des cigarettes, des allumettes ou des cendres chaudes. 13. Ne faites pas fonctionner cet appareil sans le filtre. 14. Évitez la mise en marche accidentelle. Vérifiez que l’interrupteur marche/arrêt est en position d’arrêt avant de saisir l’appareil ou de le porter.
Applications 1. Ce nettoyeur de sol sans fil doit être utilisé sur les sols durs en intérieur, tels que le vinyle, le carrelage, le parquet, etc. L’utilisation sur une surface rugueuse ne permet pas d’obtenir les meilleures performances. 2. Tenez votre appareil à l’écart des sources de chaleur, telles que la cheminée ou le chauffage, afin d’éviter toute déformation du boîtier. 3.
3. Tenir hors de portée des enfants. Éviter le contact avec les yeux et la peau, sinon rincer abondamment à l’eau. Consulter un médecin si l’irritation persiste. En cas d’ingestion du produit, consulter immédiatement un médecin. 4. La mise au rebut de l’eau sale et de la solution doit être conforme aux réglementations environnementales locales. FR À propos de l’appareil 1. Ne modifiez pas et n’essayez pas de réparer l’appareil sauf comme indiqué dans les instructions de fonctionnement et de nettoyage. 2.
Déclaration FCC relative à l’exposition aux rayonnements Cet équipement est conforme aux limites d’exposition aux radiations définies par la FCC pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre l’émetteur de radiations et n’importe quelle partie de votre corps. Remarque Le fabricant n’est pas responsable des interférences radio ou TV causées par des modifications non autorisées de cet équipement.
FR Spécifications Produit SÉRIE FLOOR ONE S5 PRO 2 Entrée CA 100-240 V~ Tension 21,6 V Puissance d’alimentation 220 W Autonomie AUTO/ULTRA/ASPIRATION : environ 35 minutes MAX : environ 28 minutes Durée de la recharge 4 à 5 heures Débit d’eau 30~100 ml/min. Capacité du REP environ 0,8 L Capacité du RES environ 0,7 L Étanchéité IPX4 4 000 mAh Lion • À n’utiliser qu’avec le chargeur TINECO S030-1B260100HU ou KL-WA260100-A3.
Description A O B C P Q J D K R L M S E F G T H N A. Bouton de nettoyage automatique K. Déverrouillage du réservoir d’eau propre B. Mode AUTO/MAX/ULTRA/ ASPIRATION L. Poignée du réservoir d’eau propre C. Marche/arrêt M. Réservoir d’eau propre (REP) D. Affichage numérique N. Rouleau brosse E. Déverrouillage du réservoir d’eau sale O. Solution de nettoyage et de désodorisation F. Poignée du réservoir d’eau sale P. Outil de nettoyage G. Réservoir d’eau sale (RES) Q.
Accessoires Remarque : Les accessoires peuvent varier selon les marchés. Si vous avez besoin de plus d’accessoires, veuillez aller sur le site www.tineco.com ou store.tineco.com. FR Solution de nettoyage et de désodorisation Élimine la saleté, la graisse et les taches tenaces de la plupart des types de surfaces dures, comme le carrelage, le marbre, le parquet, etc. Utilisez toujours la solution Tineco avec votre appareil. Ajouter un bouchon de flacon de solution dans le réservoir d’eau propre.
Assemblage Comment assembler/désassembler l’appareil Remarque : FR Pour l’ensemble constitué du réservoir d’eau et de la brosse, reportez-vous aux sections « Fonctionnement » et « Entretien ». clic Pour fixer la poignée, insérez-la dans l’appareil jusqu’à ce que vous entendiez un clic. Dans le cas où la poignée doit être démontée, appuyer sur le ressort pour libérer la poignée à l’aide d’un outil (par exemple un tournevis) et soulever la poignée de l’appareil.
Fonctionnement Préparation à l’utilisation Avant la première utilisation, veuillez charger l’appareil pendant 4 à 5 heures (reportez-vous à la section « Instructions de chargement » pour plus de détails). * Basé sur les résultats des tests de laboratoire Tineco. Température de laboratoire 4 °C à 40 °C. Conseils : (Mode ASPIRATION non disponible) FR • Mode Solution/Mode Eau seulement : L’appareil démarre en mode Solution par défaut.
Remplissage du réservoir d’eau propre Appuyez sur le bouton de déverrouillage du réservoir d’eau propre pour le retirer de l’appareil. Ouvrez le bouchon du réservoir et remplissezle d’eau du robinet jusqu’à la ligne Max. Si un nettoyage en profondeur est nécessaire, ajoutez un bouchon de flacon de solution dans le REP et fermez fermement le bouchon. Remarque : Utilisez uniquement de l’eau dont la température est inférieure à 60 °C. N’UTILISEZ PAS D’EAU CHAUDE.
