Operation Manual

8
TIP: Ifgoalissettobemeasuredindistance,stepequivalentisautomaticallycalculatedusingpersonal
settings.Ifgoalissettobemeasuredinsteps,distanceequivalentisautomaticallycalculated.
Calibrating the SenSor aUtomatiCally
Calibrate the sensor for more accurate pace and distance calculations.
1. PressMODEtoselectSETUP.
2. PressSTART/STOP/RESET/-toselectSTRIDESETUP.
3. PressandholdSETuntilvaluestoeditash.
4. Press+and-toselectAUTOMATIC.PressNEXT.
5. Press+and-toselectWALKorRUN.
6. PressNEXTand+/-tosetthousandsdigitofCAL.LENGTH(thisisthedistancetowalkorruntocalibrate).
7. ContinuepressingNEXTand+/-tosetremainingdigits.PressNEXTwhennished.
8. Whenprompted,holdSTART.
9. Whenprompted,walkorrunselecteddistance.
10. Whendistanceisreached,pressSTOP.
IfCALIBRATIONOKAYdisplays,setupiscomplete.IfCALIBRATIONFAILEDdisplays,repeatcalibration.
TIP:Longerdistancesmakemoreaccuratecalibrationsthanshorterones.Thedefaultdistanceisthedistance
ofafootballeldfromendzonetoendzone(300ftor91m).
Calibrating the SenSor manUally
1. Ifyouknowyourstridelength,youcanentertheexactmeasurementwithoutrunningautomatic
calibration. Calibrating the sensor to your precise stride length will result in the most accurate distance
calculations from Health Tracker
™
watch.PressMODEtoselectSETUP.
2. PressSTART/STOP/RESET/-toselectSTRIDESETUP.
3. PressandholdSETuntilvaluestoeditash.
4. Press+and-toselectMANUAL.
5. Press+/-andNEXTtosetstridelengthinfeet(meters)andinches(centimeters).
6. PressDONEtosavesettingsandexit.
indiglo
®
night-light/night-mode
®
featUre
1. PressINDIGLO
®
buttontoactivatenight-lightforseveralseconds.
2. HoldINDIGLO
®
buttonfor4secondstoactivateNIGHT-MODE
®
feature.Beepwillsound.
3. InNIGHT-MODE
®
feature,pressanybuttontoactivatenight-light.
4. HoldINDIGLO
®
buttonfor4secondstoturnoffNIGHT-MODE
®
feature.Beepwillsound.NIGHT-MODE
®
feature automatically turns off after 8 hours.
BATTERY
Batterytypeisonwatchback.Batterylifemayvarydependingonactualusage.
1. Rotatebatteryhatchcounter-clockwise,followingOPEN
arrow.Removebatteryhatch(useacoinifbatteryhatchis
difficult to remove).
2. Rotateplasticcovercounter-clockwiseuntilOPEN
r icon
pointstowardtopofwatch.Removeplasticcover.Remove
battery.
3. Insertnewbattery.
4. Replaceplasticcover.Assurethemetaltabisabovethe
plasticcover.RotateplasticcoverclockwiseuntilCLOSEr
icon points toward top of watch.
5. Followthepointedarrowandpresswithapaperclipthepad
in deep hole to reset.
6. Replacebatteryhatch.Rotatehatchclockwise,following
CLOSEarrow.
TIP: Tohelppreservebatterylife,youcanturntheactivitysensoroffintheSYSTEMSETUPmenu.Watchwill
not count steps when sensor is off.
CLOSE
OPEN
1
2
CR2032
CLOSE
OPEN
ROTATE COVER
TO REMOVE/REPLACE
BATTERY
PRESS PAD
TO RESET
PRESSIN
HOLEWITH
PAPERCLIP