Quick Start Guide

16 17
• The third display shows the average cadence and power values from the
bike sensor.
NOTE: If sensors are not connected to the Global Trainer
™
Bodylink
®
System
watch, their corresponding data is not shown.
Change Views During a Workout
You can change view screens during a workout to see different performance
data.
1. Start the workout as described above.
2. Press  to change view screens.
NOTE: The chronograph will continue to run, as indicated by the chrono icon
on the status bar, until you press BACK/STP/RST to stop the workout.
Stop a Workout
1. While the chronograph is running, press q. The CHRONO STOPPED message
displays.
2. Hold q for 2 seconds. The SAVE WORKOUT AND RESET? Screen displays.
3. Press  or q to highlight YES, NO, or RESET ONLY, then press 8 to confirm
your choice.
Take a Lap or Split
Press START/SPLIT when the chronograph is running to take a lap or split. Up to
three displays will appear in sequence.
NOTE: While the lap data is being displayed, the chrono has begun timing the
next lap.
• The first display shows the lap number, lap time, and split time.
• The second display shows the lap number, average heart rate, average
pace, and average speed for the lap.