SOFTWARE VERSION 2.80 GRAPHIC SPECS w260 NA QSG (EFSP) 229-095003 Program Name: W260_NA_GPS QSG Regions: (pick one) U.S. North America International Global File Name: W260_M229_GPS_QuickStartGuide_Release2 Designer(s):MSaleeby Trim Size: 3.5” x 3.5” Colors used: 4-Color Process Varnish: On cover only.
English page 2 Français page 30 Español page 60 Português page 90 Table of Contents Important Safety Instructions and Warnings.................................................. 2 Introduction.......................................................................................................... 3 Feature Overview................................................................................................... 3 Operational Buttons and Icons .....................................................
Important Safety Instructions and Warnings 1. To prevent risk of fire, chemical burn, electrolyte leak and/or injury from. the internal Lithium-polymer battery: A. Do not attempt to remove the case-back or exterior shell of the product or remove the non-user-replaceable battery. B. Do not leave unit exposed to a heat source or in a high temperature location (such as in the sun or in an unattended vehicle). To prevent damage store it out of direct sunlight. C. Do not puncture or incinerate. D.
• ANT+™ Wireless Sensors – Monitor your Heart Rate to maintain the level of activity that matches your personalized workout needs. Use Bike Speed, Cadence, and Power Meter data to integrate cycling into your workouts. NOTE: Because the Global Trainer™ watch can show languages in addition to English for its displays and messages, the screens shown in the instructions will be available on your watch in your selected language.
START / SPLIT Press START / SPLIT in PERFORMANCE or MULTISPORT Mode to begin timing a workout. Press it again when the chronograph is running to take a split and to time laps individually. Status Bar The status bar appears at the bottom of all screens. It shows the battery charge remaining, the current time, and status icons to give an at-a-glance view of the Global Trainer™ watch’s status. Status Bar Display Icons Shows the approximate charge of the battery. More dark segments indicate a higher charge.
The Power Off Function is set to SHOW TIME, so the date and time will display during charging. A blinking battery icon appears during charging. A solid battery icon appears when charging is complete. To learn more about the Power Off Function, refer to the section on CONFIGURE (Mode) and the MODES section of the USER GUIDE. Use only the Phihong PSB05R-050Q power adaptor supplied with this product.
4. The Global Trainer™ watch searches for the heart rate strap for up to ten seconds. When the strap is successfully paired, the field next to HEART RATE will read HR. NOTE: The Global Trainer™ watch can be paired with other ANT+™ wireless sensors for Bike Speed, Cadence and Power. Start at Step 1 above to pair with any of the listed ANT+™ devices. Setting Group Enter a value for the maximum heart rate in beats per minute.
Configure Heart Rate Alerts Settings 1. Press MODE until CONFIGURE displays, and press q to highlight ALERTS. 2. Press q to highlight SETUP ALERTS, and press 8 to confirm your selection. 3. Press q to highlight HEART RATE ZONE, and press 8 to confirm your selection. 4. Press or q to to highlight the setting to change, and press 8 to open the setting change window. 5. Press or q to highlight the setting in the setting change window, then press 8 to confirm your selection.
. Repeat from the beginning to change the number of fields or data in any of the other view screens. The explanation of each data field can be found in the USER GUIDE. See the steps to Choose the Number of Fields and Select Performance Data in the PERFORMANCE (Mode) View Screens section of those instructions. NOTE: The first time you wear the Global Trainer™ watch, this GPS signal fix may take several minutes. For subsequent sessions, the GPS signal fix should take 30 to 90 seconds.
Take a Lap or Split Press START/SPLIT when the chronograph is running to take a lap or split. Up to three displays will appear in sequence. • The third display shows the average cadence and power values from the bike sensor. NOTE: While the lap data is being displayed, the chrono has begun timing the next lap. . • The first display shows the lap number, lap time, and split time. NOTE: If sensors are not connected to the Global Trainer™ Bodylink® System watch, their corresponding data is not shown.
sports as well. Choose the Data View Screens for each of up to five sports that you set in PERFORMANCE Mode, and use the transition periods in between sports to prepare for the next activity in the MULTISPORT sequence. For more information on MULTISPORT Mode, its setup and its operation, see the appropriate sections under MULTISPORT (Mode) in the USER GUIDE. . If you select YES, the chronograph will reset and the workout data will appear in Review mode. If you select NO, the chronograph is not reset.
-- HANDS FREE controls automatic starting, stopping, and splits on the . chronograph. -- ALARM sets an alert that will sound at the selected times and days. -- BIKE manages profiles for up to five bikes. -- POWER METER calculates and displays bicycle power meter zones. -- GPS configures options for the GPS signal processing and the Global Trainer™ watch software version. -- UNITS configures the type of units for tracking performance data.
longer use will decrease the battery life. Replace the sensor transmitter battery if either of these conditions arise: • When the sensor is properly placed on your chest, the Global Trainer Bodylink® System watch cannot read heart rate data. • Heart rate error messages (such as SEARCHING FOR HEART RATE . . . ) appear more frequently. ™ To Replace the Heart Rate Sensor Battery 1. Use a coin to open the battery compartment cover on the back of the . sensor. 2.
and Canada only, the completed original Repair Coupon or a written statement identifying your name, address, telephone number and date and place of purchase. Please include the following with your Heart Rate Monitor to cover postage and handling (this is not a repair charge): a US$ 8.00 check or money order in the U.S.; a CAN$7.00 cheque or money order in Canada; and a UK£2.50 cheque or money order in the U.K. In other countries, Timex will charge you for postage and handling.
Declaration of Conformity Manufacturers Name: Timex Group USA, Inc. Manufacturers Address: 555 Christian Road Middlebury, CT 06762.
