Operation Manual

will need to be reset prior to using the chronograph func-

tion again or before changing to a different mode. (Please

note: button A is disabled when the maximum four hour

time has elapsed and will not function until the chrono-

graph has been reset by pressing button B).

COUNT-DOWN TIMER

The watch provides a count-down timer function.

Special note: The upper hand, lower hand, and 4th

center hand are united during steps 3, 4 and 5 below. As

you move the minute and second hands forward/back-

ward, you will see all three hands reacting to the addition

or subtraction to the length of time for the countdown

timer duration. After pulling the crown out to the middle

position, pressing button C will advance you through the

cycle of hand engagement as follows: Upper hand (press

button C) - Lower hand (press button C) - 4th Center hand

(press button C) back to Upper hand….this allows you to

advance through the cycle to engage the hands you need

to adjust to achieve setting the desired length of time to

count down. Pressing the crown in will end the setting

procedure and conﬁrms the values set so far at any point

in this cycle.

SETTING THE COUNTDOWN TIMER

The countdown timer may only be set when the count-

down timer function is not in operation. If the countdown

timer was previously used, it will need to be reset. If the

timer is currently in operation, it must be stopped and

reset in order to set the countdown timer.

1. Press button C until the upper hand is at some point

on the Timer scale. If the Timer has previously been