Operation Manual

date to your local date, continue rotating the crown to

position the hands to the current local time, being mindful

of am/pm. Once the time is set, push the crown back in

to the closed position. In normal operation the 4th center

hand will display the date when the crown is pushed.

The hand will travel to the position of the current date as

shown on the top ring of the case. The hand will pause

for you to be able to read the date and then return back

to the 12 o’clock resting position. Please note that the

Perfect Date

™

function will only operate in the Time

mode. When the battery is depleted and is replaced, the

Perfect Date function must be recalibrated. When the

battery requires replacement, it is highly recommended

the watch be sent to a Timex service center, where the

battery will be replaced and the Perfect Date function will

be recalibrated to the current date for the location where

the watch is to be returned.

4TH CENTER HAND ADJUSTMENT

To readjust a misaligned 4th center hand:

1. Pull the crown out to position 3. The upper and lower

hands reset to the ends of their sweeps automatically.

2. Within 10 seconds of pulling the crown to position 3,

the 4th center hand should point to 12 o’clock, if it

does not point to 12 o’clock, press button A or B to

move the hand counterclockwise or clockwise until

it points to 12 o’clock. Pressing and holding button A

or B will make the hand move at a fast rate. Please

note: after 5 seconds without action with the crown

in position 3, the 4th center hand will move to display

the current date.

3. Push crown in to position 1 when ﬁnished.