Instructions

NOTE: The date function advances the date between the hours of
9 PM and 12 AM. Avoid setting the date during this time frame. If
you attempt to set the date during this time, rotate the crown at a
very slow rate to avoid damaging the watch and set the date for the
following date, as the date will not advance if set during this time
frame. When resetting the time and date after a battery change it
is recommended to set the time to the date before the current date
and then setting the time by moving the hands forward until the
date changes to the current date, and then continuing to advance
the hands forward to the current time.
TO SET THE TIDE CYCLE HAND:
The Tide cycle hand steps forward every 12 minutes 24.4 seconds,
one full turn takes 12 hours 24 minute and 24 seconds (one high tide
and one low tide). CONSULT THE LOCAL TIDE TIMETABLE PRIOR
TO SETTING THE TIDE CYCLE HAND.
1. PUSH AND HOLD pusher “A” for approximately one second to
activate the setting mode. The tide cycle hand will advance one
position as the setting mode is activated.
2. PUSH pusher “A” to advance the tide cycle hand one position
(PUSH AND HOLD pusher “A” to advance the tide cycle hand
quickly). Repeat until the tide cycle hand is in the desired
position.
NOTE: To prevent accidental resetting of the tide cycle hand If
pusher “A” is not pushed within 10 seconds of the setting mode
being activated the setting mode is automatically deactivated.