Use Instructions
8 | EN Healy GmbH | Schloss Kränzlin | Darritzer Str. 6 | 16818 Kränzlin – Germany
3.1.4 Hardware
• Unpack the Healy and check for damage
• Charge the batteries for 1.5 hours before rst use
• Switch on the Healy device by briey pressing the on-switch
and verify that the right LED is blinking
Note: The battery cannot be removed by the user.
3.1.5 Pairing via Bluetooth
After installation of the App, switch on the Healy by briey push-
ing the on-switch (see gure 2.4 .1.1) of the device.
After starting the App there is a short starting screen (see g-
ure 3.1.5.1).
After the App is loaded it is scanning for Bluetooth devices (see
gure 3.1.5.2).
Within 20 seconds the App scans the environment and connects
to the Healy automa tically. If your smartphone detects a Healy
gure 3.1.5.3 appears.
After you scan the QR-Code on the back of the Healy or enter
the serial number of the device you can connect to the Healy by
pressing the “Connect” button (see gure 3.1.5.4).
3.1.6 Connection of the Electrodes
The electrodes have been tested and evaluated together with
the Healy and are safe and eective for use, if the recommenda-
tions and advice in this manual are followed. Check the package
containing the electrodes and make sure the gel is intact; if the
package is visibly dented or damaged, do not use the product.
Put the plugs of the electrode cables into the sockets of the
Healy. Be sure to have the correct polarity. Place the electrodes
onto the desired treatment area.
Figure 3.1.5.2:
Scanning screen
Figure 3.1.5.1:
Starting screen