Use Instructions
10 | EN Healy GmbH | Schloss Kränzlin | Darritzer Str. 6 | 16818 Kränzlin – Germany
• After the session, turn o the electrostimulator, disconnect
the cable from the electrode and gently remove the electrode
from the skin by lifting it up by one corner.
• Rapid removal of the electrode could cause skin traumas.
• Do not remove by pulling the connection part of the cable.
• After use, reposition the electrodes in the plastic liner and put
them back in the pouch.
• Electrodes may be reused: Reuse only for the same person.
• Verify the adhesion of the electrode before use. When elec-
trodes lose adhesion, gently rub one or two drops of water on-
to the gel surface. This may extend the usability. If there is no
improvement, replace with new electrode.
• Keep the packet closed in order to prevent the unused elec-
trodes from becoming dehydrated.
• Do not reposition the electrode during use.
4. Operating the Healy Device
You should become familiar with these frequently used opera-
tions:
• switch On-O (please refer to chapter 4.1.5 and 5.4)
• select treatment (please refer to chapter 5.1)
• start stimulation (please refer to chapter 5.1)
• connect the electrodes (please refer to chapter 4.1.6)
4.1 Starting the Treatment Using the Smartphone
After the installation of the App, pairing and connection of the
electrodes, the Healy is ready for operation. In the overview
screen you can select which program category you want to use
(see gure 4.1.1).
After selecting a program category the program page with the
icons of the dierent programs is loaded (see gure 4.1.2).
After you select a program from the program page screen the
information for placing the electrodes is displayed (see gure
4.1.3).
After selecting “Start” on the information page the treatment is
started and the treatment page is displayed (see gure 4.1.4). In
the treatment page you can set the intensity of the treatment by
using the plus and minus buttons.
When the electrical circuit is closed the circle, which is an indica-
tor for the time, will switch from black to white (see gure 4.1.5).
4.2 Handling of the Healy Hardware
During the treatment you should use the clip on the back of
the device to attach the Healy to your clothing. The electrodes
should be axed as shown in the App (please refer to chapter
10). Route the electrode cables to the Healy so that you feel com-
fortable.