Instruction Manual

9. Setting up for Automatic Operation

• Turn the Lux Adjustment fully anti-clockwise to the Moon symbol.

• Turn the On-time Adjustment to the desired setting (10 seconds

Minimum to 15 minutes Maximum).

• When the ambient light level reaches the level of darkness at

which you wish the lamp to become operative once motion is

detected (i.e. at dusk) SLOWLY rotate the control in an clockwise

direction, whilst moving (e.g. your hand) in front of the sensor,

until a point is reached where the lamp illuminates.

• Leave the Lux Adjustment set at this point.

• At this position, the unit should become operative at

approximately the same level of darkness each evening

each time motion is detected.

Adjustments

• If you find that your lights switch on when it is too dark, turn the

Lux Adjustment clockwise towards the Sun symbol.

• If the light is in operation when it is too light, turn the Lux

Adjustment towards the Moon symbol.

Fig 7 – On-time and Lux Adjustment

1 ~ 10lux

Lux Adjustment On-time Adjustment

min 10s max 15min