Instruction Manual

8. Walk Test

Note: If the DIP Switch is set to the ON position, also make sure the

Slide Switch is set to the AUTO (middle) position.

• Set the On-time adjuster fully anticlockwise to the min

10s position.

• Set the Lux adjuster fully clockwise to the SUN symbol.

• The light switch will now operate during the daytime as well as

at night, illuminating your lights for approx. 10 seconds each

time. This allows testing to be carried out to establish whether

the sensor is covering the required area.

• Walk in front and around the sensor to establish the detection

area. The sensor will detect motion within an 10m diameter

(walking across), and within a 3m range (walking towards)

with the sensor mounted at 1m.

• As you cross the detection ‘zone’ your lights will illuminate.

Now stand still until your lights extinguish (this should take

approx. 10 seconds).

• Start moving again after 2 seconds until your lights turn ON.

• Repeat the above, walking at various distances and angles from

the light switch. This will help you confirm the detection pattern.