Instruction Manual

2
4. Installation
• Remove the front of the unit by undoing the 4 bolt sremove the
bezel and lens with gasket.
• Mark the position of the mounting holes on the wall using the unit
as a template.
• Drill the holes for the wall plugs ensuring not to infringe with any
gas/water pipes or electrical cables that may be hidden below the surface.
• Undo the cable gland sufficiently to allow the cable to be pushed through
the back.
• Secure the supply cable into the luminaire through the hole(s) provided
ensuring that a cable gland, grommet or sealing compound is used
to maintain the IP rating of the luminaire.
• Leave enough slack to allow for wiring, re-tighten the cable gland.
• Fix the luminaire using the correct screws for the wall plugs installed.
• Terminate the cable into the terminal block (see section 5 connection diagram)
ensuring correct polarity is observed and that all bare conductors are sleeved.
• Secure the supply cable using the cable clamp.
• Reposition the lens over the unit, taking care to ensure the gasket is in place.
• Secure the lens and bezel back into place using the 4 bolts previously
removed at the beginning of the installation.