Instruction Manual

8.Switching from Absence to

to Presence mode

• To switch the PIR from absence to presence mode, press the

lock/unlock button and you will see 2 flashes from the

LED receiver of the PIR. Next press the Auto button on

the IR10AB remote control. The LED receiver light will flash

twice and dissapear, this indicates that the PIR is now in

Auto (presence mode). There will be up to a 1 minute delay

in changing modes where the PIR will not switch.

9.Changing the PIR sensitivity

• To alter the sensitivity level of the PIR, press the lock/unlock

button and you will see 2 flashes from the LED receiver

of the PIR, this indicates that the PIR is unlocked and ready

to receive further instructions from the remote control.

• Next press either the +sens button to increase the level

of sensitivity or the –sens button to decrease the level

of sensitivity of the PIR.

10.Manual Override Mode

• To set the manual override on the PIR, press the lock/unlock

button and you will see 2 flashes from the LED receiver

of the PIR, this indicates that the PIR is unlocked and ready

to receive further instructions from the remote control.

• Next press either the ON button, or the OFF button

to set manual override mode for a 10 hour perminant ON

or OFF period. Once the 10 hour period has ended the PIR

will default to Auto mode.