Instruction Manual

• To switch the PIR from presence to absence mode, press the

lock/unlock button and you will see 2 flashes from the

LED receiver of the PIR, this indicates that the PIR is unlocked

and ready to receive further instructions from the remote

control.

• Next press the Semi Auto button on the IR10AB

remote control. The LED receiver light will flash once for up

to 2 seconds and dissapear, this indicates that the PIR is now

in Semi Auto (absence mode).

• When the PIR set to absence mode, the unit will not switch

on automatically when someone walks in the detection area.

• The person in the room must press the retractable push

button for the light to switch on. From this point onwards as

long as detection in the area has constant movement, the

PIR will continue to keep the luminaire or attached load

swtiched on, until the subject has moved out of the detection

area and the time delay function takes over.

• For example if set to 10 minutes the PIR will begin to

countdown from this value once nothing is in the detection

area. If a subject is detected the time delay will reset.

7.Switching from Presence to

to Absence mode