Instruction Manual

6.Changing Time Delay Values

• Then press the Auto button on the remote control,

the LED receiver light will flash twice signaling the PIR is

ready for instructions.

• Next press the LUX value you require, the receiver light will

flash twice. Note that the LUX value change does not apply

to the second channel as HVAC controls will switch on at

any time when someone enters the detection area.

Note only PDFM362AB supports a second channel that

can be programmed via the remote control.

• To modify the Time Delay value using the remote control,

press the lock/unlock button on the remote control to

lock and then unlock the PIR. There will be x2 flashes from

the LED receiver of the PIR, this indicates that the PIR is

unlocked and ready to receive further instructions from the

remote control.

• Then press the Auto button on the remote control,

the LED receiver light will flash twice signaling the PIR is

ready for instructions.

• Next press the Time Delay value you require, the receiver

light will flash twice. Then select the channel to apply these

new settings to i.e. channel 1 button CH1 or channel 2

button CH2.