For Use With PDFM361AB, PDFM362AB & PDSM361AB Installation & Operating Instructions IR10AB Infra-Red Remote Contol
1. General Information These instructions should be read carefully and retained for further reference and maintenance. Note: Timeguard reserve the right to alter these instructions at any time. Up to date instructions will always be available for download at www.timeguard.com 2. Safety • To clean use a clean dry cloth only. Do not use liquid cleaners. 3.
4. Button Fuctions 2 • LUX control adjustment. (Auto mode only). • Time delay adjustment (up to 60 minutes Auto mode only). • Independant channel control (PDFM362AB only). • Sensitiveity control. • Manual override ON/OFF (10 hours). • Learn mode: Set for a specific Lux level. • Lock/Unlock PIR settings. • Semi Auto mode: Absence • Auto mode: Presence • Pulse mode 5. Changing Lux Values Note that Lux value changes are subject to Presence mode (Auto) only.
• Then press the Auto button on the remote control, the LED receiver light will flash twice signaling the PIR is ready for instructions. • Next press the LUX value you require, the receiver light will flash twice. Note that the LUX value change does not apply to the second channel as HVAC controls will switch on at any time when someone enters the detection area. Note only PDFM362AB supports a second channel that can be programmed via the remote control. 6.
7.Switching from Presence to to Absence mode 4 • To switch the PIR from presence to absence mode, press the lock/unlock button and you will see 2 flashes from the LED receiver of the PIR, this indicates that the PIR is unlocked and ready to receive further instructions from the remote control. • Next press the Semi Auto button on the IR10AB remote control. The LED receiver light will flash once for up to 2 seconds and dissapear, this indicates that the PIR is now in Semi Auto (absence mode).
8.Switching from Absence to to Presence mode • To switch the PIR from absence to presence mode, press the lock/unlock button and you will see 2 flashes from the LED receiver of the PIR. Next press the Auto button on the IR10AB remote control. The LED receiver light will flash twice and dissapear, this indicates that the PIR is now in Auto (presence mode). There will be up to a 1 minute delay in changing modes where the PIR will not switch. 9.
3 Year Guarantee 6 In the unlikely event of this product becoming faulty due to defective material or manufacture, within 3 years of the date of purchase, please return it to your supplier with proof of purchase and it will be replaced free of charge. For years 2 to 3 or with any difficulty in the first year, telephone our helpline. Note: a proof of purchase is required in all cases.
If you experience problems, do not immediately return the unit to the store. Email the Timeguard Customer Helpline: HELPLINE helpline@timeguard.com or call the helpdesk on 020 8450 0515 Qualified Customer Support Coordinators will be online to assist in resolving your query. For a product brouchure please contact: 67.058.685 (Issue 1) T.W - October 2021 Timeguard Limited. Victory Park 400 Edgware Road, London NW2 6ND Sales Office: 02084521112 or email csc@timeguard.com www.timeguard.
