User's Manual

S1C Manual page : 9
OEM Responsibilities
The Product name here Module has been certified for integration into products only by
OEM integrators under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of
20cm is maintained between the radiator (antenna) and all persons at all
times.
2. The transmitter module must not be co-located or operating in conjunction
with any other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end-product for
any additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for certain
configurations or co-location with another transmitter), then Industry Canada and FCC
certification is no longer considered valid and the IC & FCC Certification Numbers cannot
be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate Industry Canada authorization.
End Product Labeling
The Product Name here Module is labeled with its own IC and FCC Certification Numbers.
If the Certification Numbers are not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. In that case, the final end product must be labeled
in a visible area with the following:
“Contains Transmitter Module IC10427A-TCB11”
Contains Transmitter Module FCC ID: AYV-TCB11”
or
“Contains IC: 10427A-TCB11”
“Contains FCC ID: AYV-TCB11”
The OEM of the Product Name here Module must only use the approved antenna(s) listed
above, which have been certified with this module.
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user’s
manual of the end product.
The user’s manual for the end product must include the following information in a
prominent location:
“To comply with Industry Canada and FCC RF radiation exposure limits for general
population, the antenna(s) used for this transmitter must be installed such that a minimum
separation distance of 20cm is maintained between the radiator (antenna) and all persons
at all times and must not be co-located or operating in conjunction with any other antenna
or transmitter.”