User's Manual

More on menus
Each menu allows further customisation of your Timecode Systems SyncBac PRO
Timecode Mode. Choose from five settings:
• GP Master TX. This is a mode where the unit is the 'master clock', transmitting T/C to
all SyncBac PRO 'RF slave' devices.
• RF Slave. This is a mode where the unit acts as a 'slave' receiving unit, constantly
locking to the incoming RF timecode from a :pulse mini base station & sync data, soft
jamming & chasing the incoming T/C from an RF master unit. The SyncBac unit acts as a
BLINK slave unit, sending its status and settings back to the BLINK master unit. It also
sends back the status of the connected GoPro HERO4 camera (if attached). When the
camera is attached it can also be remotely controlled from the BLINK master unit via the
applications.
TC Generator. Choose from:
• Set T/C. Turn to set flashing digits, press to enter. Repeat for each pair.
• Set FPS. Set to 23.976, 25 or 29.97
Set RF Channel Number. Select the RF channel group for Transmit or Receive (depending
on the timecode mode selected from the menu).
System Settings.
• Set RF country/area. Locked to FCC/IC Band
 Set LED brightness. Sets the brightness of the Tri-colour LED
• Set factory defaults. To remove any customisation.
Display Settings.
• Set Brightness. Allows you to change the level of brightness from 1 through to 100.
(100 being the brightest)
• Flip Display. Flip the display 180 degrees
• Short Timed ON. Stays bright for a short duration, then dims
• Long Timed ON. Stays bright for a longer duration, then dims
• Always ON. Stays bright at the Set Brightness level.