User's Manual


UK Timecode Systems Ltd. Unit 6, Elgar Business Centre, Moseley Road, Hallow, Worcester.
WR26NJ. UK


ISEDCanada
ISEDCanada(English)
ThisradiotransmitterhasbeenapprovedbyIndustryCanadatooperatewithitsembedded
antenna.Otherantennatypesarestrictlyprohibitedforusewiththisdevice.Thisdevicecomplies
withIndustryCanada’slicense‐exemptRSSstandards.Operationissubjecttothefollowingtwo
conditions:
1.Thisdevicemaynotcauseinterference;and
2.Thisdevicemustacceptanyinterference,includinginterferencethatmaycauseundesired
operationofthedevice.
RFExposureStatement
ExceptionfromroutineSARevaluationlimitsaregiveninRSS‐102Issue5.AirGlu™modulemeetsthe
givenrequirementswhentheminimumseparationdistancetohumanbodyislessthanequalto15
mm.RFexposureorSARevaluationisnotrequiredwhentheseparationdistanceis15mmormore.
AirGlu™modulehasbeentestedforworstcaseRFexposure.AsdemonstratedintheSARtest
report,AirGlu™canbemountedintouchwithhumanbodywithoutfurtherSARevaluation.Ifthe
separationdistanceofAirGlu™islessthan15mmtheOEMintegratorisresponsibleforevaluating
theSAR.
OEMResponsibilitiestocomplywithICRegulations
Thetransmittermodulemustnotbeco‐locatedoroperatinginconjunctionwithanyotherantenna
ortransmitter.RadiatedemissionmustbetestedwitheachnewhostproductandISEDCmustbe
notifiedwithaClass4PermissiveChange.OEMintegratorisresponsiblefortestingtheirend‐
productforanyadditionalcompliancerequirementsrequiredwiththismoduleinstalled(for
example,digitaldeviceemissions,PCperipheralrequirements,etc.).
Importantnote
Intheeventthattheseconditionscannotbemet(forcertainconfigurationsorco‐locationwith
anothertransmitter),thentheICauthorizationisnolongerconsideredvalidandtheICIDcannotbe
usedonthefinalproduct.Inthesecircumstances,theOEMintegratorwillberesponsibleforre‐
evaluatingtheendproduct(includingthetransmitter)andobtainingaseparateICauthorization.
EndProductLabeling
TheAirGlu™moduleisnotlabeledwithICIDbecauseofitssmallphysicalsize.Thefinalendproduct
mustbelabeledinavisibleareawiththefollowing:
“ContainsTransmitterModuleIC:10427A‐AGLU01”
Or
“ContainsIC:10427A‐AGLU01”
TheOEMintegratorhastobeawarenottoprovideinformationtotheenduserregardinghowto
installorremovethisRFmoduleorchangeRFrelatedparametersintheusermanualoftheend
product.









