User Manual

1077 Technical Manual Page | 11

4.7. Opera ti on a s a Curre nt Source

As a current source the 1077 will

supply the set cur rent to the load

1. Check the setting of the output volt age control as in Sec t ion 3.1.

2. Turn on and select ‘Source’ mode.

3. Select most suitable range and set output on digit switches.

4. Connect ‘Load’ and turn output switc h O N.

Note: If V limit LED illuminates the 1077 has insufficient drive voltag e t o output the current

set. See ‘Output Voltage Control’ Section.