Operation Manual

8
Taking a Reading
Press the START/STOP button to begin the reading, the monitor
will automatically start to measure your blood pressure. Please
remain still whilst the monitor works.
The cuff will start to inflate and the rising pressure in the cuff will
be displayed on the screen.
Once a suitable pressure has been reached, the cuff will stop inflating and gradually
loosen. The drop in pressure will also be displayed on the screen.
In case the cuff pressure is insufficient, the device will
automatically re-inflate to a higher pressure.
When the monitor detects a pulse, the heart symbol on the screen
will start to flash.
Once the reading has completed, the systolic, diastolic and pulse
rate will appear on the screen.
The reading will be remain on the screen until the device is turned
off. The monitor automatically switches off if unused for 3 minutes.
If an irregular heartbeat is detected during the measurement. The
symbol will appear on the screen.
Discontinuing a measurement
If for any reason you would like to discontinue with the measurement, press the
START/STOP button. The cuff pressure will reduce immediately.
Memory-recall of measurements
The monitor automatically stores 2 x 90 sets of readings. The oldest record will be
overwritten by the most recent reading when it exceeds 90 readings per user.
Measurement record
Press the M button when the monitor is turned off to bring up an average of the last 3
readings. Press the M button again to bring up the most recent reading. Continue
pressing the M button to see previous readings.
Permanently delete all measurements
If you would like to permanently remove all stored memory. Press
the S button 7 times until the CL sign appears on the screen.
Thereafter press the START/STOP button, the CL sign will flash 3
times then clear all stored data. In order to check whether the data
has been cleared, press the M button again. and ‘NO’ will
appear on the screen.