Manualshelf

Installation Guide

ManualsBrandsTimberTech ManualsDeck Board SamplesEDGE Prime + 1 in. x 5.36 in. x 1 ft. Sea Salt Gray Composite Deck Board Sample
11121314151617181920
Page 13
FUSIONLoc
®
Hidden Fasteners Installation
1
SET UP FUSIONLOC GUN
FUSIONLoc® Hidden Fasteners for use with TimberTech Deck Boards
IMPORTANT: Deck Board must be secured tightly and in full contact with the joist after each clip is installed. Not
doing so could result in issues such as an uneven deck surface, noise, and board movement caused by an
improper loose attachment.
FUSIONLoc & Accessory Installation Instructions
• FUSIONLoc Hidden Fasteners – packaged for 225-square-foot and 450-square-foot, at 16” O.C.. Includes Stainless
Steel collated clips and collated screws.
• FUSIONLoc FiveSHOT pneumatic gun is sold separtely by FastenMaster®.
• For a completely fastener-free surface, use Cortex on the first and last boards.
• Router Bit – cut the correct groove dimension on a solid plank for a perfect FUSIONLoc fastener fit; it even allows for
notching an installed plank over a joist.
• FUSIONLoc can also can also be installed with a hand driven guide (sold separately), with screws and clips sold in 50
Sq. Ft. and 225 Sq. Ft. packs
FUSIONLoc
®
Hidden Fasteners Installation Instructions
The steps noted below must be followed to
properly adjust the FUSIONLoc Gun for the varying
requirements of the materials and profiles used in
TimberTech Decking.
• 95-115 PSI must be maintained to properly sever
the clips and drive the screws to the correct depth.
• Remove the Driver Blade Key from the back of the
tool. (A)
• Use the Driver Blade Key to raise or lower the
Driver Blade height. Holding the tool as you would
when installing a clip, turn counterclockwise to
raise the Driver Blade. (B)
Tools Needed
DrillSafety
Glasses
Router with Slot
Cutting Blade
(Optional)
FUSIONLoc
Gun
A
B
The driver blade should be set as high as it will go, while still severing the collated clip. If the clips
are not severing, lower the Driver Blade height in 1/4 turn increments until clips sever.
Please use caution while operating the FUSIONLoc FiveSHOT Gun. Air hose must be disconnected
during all adjustments of the driver blade and when not in use.