Manualshelf

Installation Guide

ManualsBrandsTimberTech ManualsComposite Decking BoardsEDGE Prime Plus Collection 0.94 in. x 5.36 in. x 8 ft. Sea Salt Gray Square Shoulder Scalloped Composite Decking Board
11121314151617181920
Page 15
• Install fastener by simply positioning the FUSIONLoc Gun, then push down on the tool to engage the
safety, and pull the trigger, while applying downward pressure on the deck board.
• Install one clip and screw at each joist.
• Make sure the clip is in full contact with edge of plank and the screw is holding the clip down tight to
the deck board. If necessary, tighten screws using provided driver bit.
• For additional installation and troubleshooting, please see insert in FUSIONLoc gun packaging.
4
5
INSTALL FUSIONLOC FASTENERS
• Place the next plank into position against the clips. Slightly raise the outer edge of the plank being
installed, and slide it onto the clip until the plank contacts the spacer tab. When properly installed the
inserted plank should be in contact with the backside of the clip legs.
• Best practice dictates using a beater board at least 24” nin length to drive the plank further onto the
clip. Proper installation yields 3/16” spacing between deck boards.
COMPLETE INSTALLATION
Deck board must be secured tightly and in full contact with the joist
after each clip is installed.
Do not use a hammer or damage to the edge of the plank will occur.
When installing decking always use a beater board against the side
of the deck board.
a.
b.
c.
FUSIONLoc
®
Hidden Fasteners Installation