Installation Guide

Page 3
If you do not have the template,
position the top of the Support
Block 4” above the deck.
INSTALL LOWER
SUPPORT BLOCK
• Position template at
bottom of Post
Sleeve above Post
Skirt.
INSTALL POST
SLEEVES
• Trim Post Sleeves to
desired length.
• Slide Post Sleeves and
Post Skirt over post
(do not force).
• Ensure posts are
square and plumb.
Optimal 39”
45°
For angled rail installations,
align angled face of Support
Block parallel to rail section.
Pre-drill 7/64”
#8 x 3/4” Coated
Screws
1/3
1/3
1/3
1/2
1/2
Foot
blocks
#8 x 3” Coated
Screws
8’ Kit
6’ Kit
Center screw aligned to
rail centerline
Center screw
aligned to rail
centerline
Bracket set
ush to rail
face
Bracket set
ush to rail
face
CUT AND ASSEMBLE BOTTOM SUPPORT RAIL
• Cut the Bottom Support Rail to length.
3
1
2
39” above deck surface is
optimal for 36” railing heights.
4”
Template
Support
Block
Post Skirt
7/64” Pre-drill
#8 x 3” Green Coated
Screws
Installing AZEK Rail with Balusters
For sections up to 6’:
Place one Foot Block in
the center of the rail.
For sections 6’ to 8’:
Space two Foot Blocks
approximately at 1/3
intervals on the rail.
For sections 8’ to 10’:
Space three Foot Blocks
approximately at 1/4
intervals on the rail.