Installation Guide

Page 9
Installing AZEK Rail Stairs with Balusters
• Rotate Rail assembly
out of way to fasten
Support Block.
Pre-drill
7/64”
#8 x 3/4”
Coated
Screws
Center screw
aligned with
rail centerline
Pre-drill
INSTALL RAIL ASSEMBLY
INSTALL BOTTOM SUPPORT RAIL
• Attach Mounting Brackets to Bottom Support Rail.
• Secure Mounting Brackets to posts.
• Wedge Foot Block under Support Rail & Attach.
8
7
Brackets must be
installed to the stair
tread side of the rail.
For sections up to 6’:
Place one Foot Block in
the center of the rail.
For sections 6’ to 8’:
Space two Foot Blocks
approximately at 1/3
intervals on the rail.
Pre-drill through
Bottom Support
Rail with 3/16” bit
Bottom
Support Rail
#8 x 3”
Screws
Mounting
Brackets
#8 x 3” Green
Coated
Screws
Pre-drill
7/64”
• Mark ends of Support
Rail.
• Secure Mounting
Brackets to Posts.
Position rail assembly
over Bottom Support
Rail.
Position rail assembly
over Bottom Support
Rail.
Pre-drill
7/64”
#8 x 3”
Green
Coated
Screws
#8 x 3”
Green
Coated
Screws