Installation Guide

Page 8
Installing AZEK Rail Stairs with Balusters
ASSEMBLE BALUSTERS
• Attach Balusters to Top and Bottom Support Rails and attach Brackets to
Top Support Rail.
6
Trim Baluster ends to required
angle as shown.
Important: Start cut at top
edge to maximize the length.
Aluminum stair Balusters are
precut to a stair angle and are
not to be cut on the job site.
TRIM BALUSTERS
• Place the Bottom Rail
and the Top Support
Rail together as
shown to keep the
holes aligned.
• Trim Foot Block to
stair angle as well.
DRILL BALUSTER
HOLES
4
5
Tip for Bottom Rail:
Partially drive screws
into all Balusters
before driving them in
completely.
Brackets must be on the
side of the rail facing
the stairs.
Bottom
Rail
Top
Support
Rail
Pre-drill 3/16”
Scrap piece
of wood cut
to stair angle
Bottom Rail
Top Support
Rail
#8 x 3” Coated
Screws
#8 x 2” Coated
Screws
Top Support
Page 8
Pre-drill
7/64”
#8 x 3/4”
Coated
Screws
Center screw
aligned with
rail centerline
Pre-drill