Installation Guide

Page 29
Installing AZEK Rail with Glass Infi ll
39” above deck surface is
optimal for 36” railing heights.
If you do not have a the template,
position the top of the Support Block 4”
above the deck.
INSTALL LOWER
SUPPORT BLOCK
• Position template at
bottom of post
sleeve above post
skirt.
CUT AND ASSEMBLE BOTTOM SUPPORT RAIL
• Cut the Bottom Support Rail to length.
3
1
2
Optimal
39”
skirt.
For angled rail installations - align
angled face of Support Block
parallel to rail section.
Page 29
Straight Section
Angled Section
Center screw aligned
to rail centerline
Foot Block
#8 x 3”
Coated
Screw
Bottom Support
Rail
1/2
1/2
Center screw
aligned to rail
centerline
Bracket set
fl ush to rail
face
Bracket set
fl ush to rail
face
Pre-drill 7/64”
#8 x 3/4”
Coated Screws
For sections up to 6’: Place one Foot
Block in the center of the rail
INSTALL POST
SLEEVES
• Trim Post Sleeves to
desired length.
• Slide Post Sleeve and
Post Skirt over post.
(DO NOT FORCE)
• Ensure post are
square and plumb.
For angled rail installations - align
angled face of Support Block
4”
Template
Support
Block
Post Skirt
7/64” Pre-drill
#8 x 3” Green Coated
Screws
7/64” Pre-drill