Instructions / Assembly

ManualsBrandsTIMBER STOVES ManualsOutdoor Heating90,000 BTU Stainless Steel Big Timber Wood Pellet Burning Patio Heater

The Wood Pellet Patio Heater

By Wood Pellet Products, PO Box 761 Mt. Angel, Oregon 97362

Owner’s manual

Big Timber Patio Heater

Model: WPPHBTSS1.0

IMPORTANT

Your safety is very important to us. Read this manual thoroughly before you install, operate and

maintain this heater. Retain this manual for future reference. If you have questions about assembly,

operation, servicing, or repair of this heater please call us directly at 877-347-2848

California Proposition 65 Warning:

This product can expose you to chemicals including carbon monoxide, which is known to the State of

California to cause cancer, birth defects and/or other reproductive harm. For more information, go to

www.p65warnings.ca.gov

Summary of content (10 pages)

PAGE 1
The Wood Pellet Patio Heater By Wood Pellet Products, PO Box 761 Mt. Angel, Oregon 97362 Owner’s manual Big Timber Patio Heater Model: WPPHBTSS1.0 IMPORTANT Your safety is very important to us. Read this manual thoroughly before you install, operate and maintain this heater. Retain this manual for future reference.
PAGE 2
Table of Contents Important Warnings…………………………….…………………………………….……...…2 Specifications…………………………………………………………..…..…….……..…..…...3 Important Safety Precautions………………………………………………....…….………. .3 Assembly……………………………………………………………………………….…….....4 Unpacking…………………………………………………………..….…………………..……4 Parts Diagram……………………………………………………………….…………………..5 Hardware List………………………………………………………………………..………...…6 Installation………………………………………..………………………………….……..…..6-8 Operation……………………………………..………………………...……………..…..…..
PAGE 3
Specifications Model No…………………………………………..……………………………………………………WPPHBTSS1.0 Type of Fuel………………………………………………….……….1/4” diameter by ½” long wood pellets Input rating ……………………………………….………….………………………….……..90,000 BTU/HR Overall Height…………………………………….…………….……………………………………. 84 Inches Reflector Diameter…………………………….…………….………………………………………. 18 Inches Ignition System……………………………….……manually light with a match and alcohol gel fire starter Electrical connections ………………………………….…………………………………….
PAGE 4
Warning: When the heater is to be operated in the presence of other people, the owner/purchaser is required to inform people unfamiliar with the operation of the patio heater of the instructions, and of the hazards involved of operation. If this heater is used in a commercial or rental installation, it is the responsibility of the purchaser to check with the local codes for properly acquainting users with the safety precautions and instructions.
PAGE 5
PAGE 6
Included in the box is a bag containing your required hardware: Count Part Application 32 10/32 x 1/2" Screws ● ● ● ● ● Attaching (B) Stove top to (K) Firebox - Uses 12 (J) Firebox Bottom to (K) Firebox - 9 (A) Stove top collar to (B) Stove top - 4 (Y) Top Reflector to (X) Stove Pipe Spark Arrestor – 3 (L) Door Mounting Bracket to (K) Firebox 6 1/4 x 1/2” Screws 6 ¼ x 7/8” Screws 7 10/32” Nuts ● (XZ) Base to (K) Firebox – 4 ● (M) Door to (L) Door mounting bracket -2 ● (Q) and (Q1) handles to
PAGE 7
inserted through slotted holes that are located just below the damper (N). The slotted holes are on all four sides of the firebox. For maximum heat output, move the screws to the lowest position within the slotted holes on all four sides of the firebox (this allows more fuel in). For use above 3,000 Ft. in elevation be sure the firebox bottom is set at the lowest position in the slots. Installing the Deluxe Fire Pot: Insert (XP) the firepot into the square cutout on the firebox bottom.
PAGE 8
easiest to place the lock seam side on to the back of the collar and pull the stove pipe forward then down over the collar. Place the stove pipe spark arrestor (connected to the top reflector) onto the top of the stove pipe section. Push down until secure. Self-tapping screws included to secure the stove pipe. Use 3 screws in each section. (Optional) Shutoff Key Operation – The stove is supplied with a hopper shutoff key and attachment rope. Ensure the key sits level with the ground when fully inserted.
PAGE 9
Lighting Open the door and squirt about two tablespoons of alcohol fire gel on the mound of wood pellets in the middle of the firebox. Pellets will have funneled down from the hopper chute. Light the alcohol fire gel with a match and close the door. Open the (N) Damper below the door for the first ten minutes of a burn. Standard burn time for the heater on one full hopper (25 lbs) is about 2.5 hours. You can extend this burn time by adding pellets to the hoppers during the burn.
PAGE 10
Trouble Shooting Problem Low heat output Solution Make sure you are using high grade pellets with a BTU rating of at least 8,200/hr. Douglas Fir pellets are recommended for highest BTU output. Proper maintenance of the stove is essential for maximum heat output. Make sure to clean out the firebox and scrape in-between the firepot bars. Clear the spark arrestor with compressed air or with a brush. Smoke/Burning Dirty A well-maintained stove with high grade pellet fuel will burn the cleanest.