Warranty Guide

5
TIMBER CHAMP
OPERATIONAL SAFETY
 ALWAYS ensure the motor is properly grounded or apply protec- tion
device. Only use rubber-jacketed cable of sufficient lead cross
section as an extension cable.
 KNOW how to stop the log splitter and disengage the controls before
operating it.
 NEVER place hands, feet or any body part between the ram and
splitting wedge during forward or reverse stroke. Serious injury or
death could result.
 NEVER straddle or step over the log splitter during operation.
 NEVER reach or bend over the log splitter to pick up a log.
 NEVER try to split two logs on top of each other.
 NEVER try to cross split a second log.
 NEVER allow one person to operate while another is positioning the log.
 NEVER attempt to load your log splitter when the ram is in motion.
 ALWAYS use your hand to operate the control lever and the switch. NEVER use
your foot, a rope or any extension device.
CAUTION:
Please be aware
that motor will
shut down if
overheated.
 NEVER move the log splitter while the motor is running. Shut off the motor when the log splitter is unattended.
 NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
 ALWAYS unplug the power cable before performing any maintenance and repair. Periodically check that all
nuts, bolts, screws, and belts are tightened properly.
 NEVER alter your log splitter in any manner such as adding a rope or extension to the control lever or
adding to the width or height of the wedge. Such alterations may cause your log splitter to be unsafe
and will void the warranty.
 ALWAYS perform all recommended maintenance procedures before using your log splitter. Replace all damaged
and/or worn parts immediately.
 NEVER tamper with the motor to run it at excessive speeds. The maximum motor speed is preset by the
manufacturer and is within safety limits.
 ALL replacement parts must meet manufacturer’s specifications.
 NEVER operate your log splitter near a flame or spark. Hydraulic oil is flammable and can explode.
 ALWAYS take a Class B fire extinguisher with you when operating this log splitter in dry areas as a precautionary
measure against possible flying sparks.
MOTOR WILL SHUT OFF
IF OVERHEATED
The motor on this
log-splitter is designed to
shut down if it is worked
to overheating. If motor
to let unit cool down and
then resume operation.