Warranty Guide

TIMBER

CHAMP

STEP 2: Remove Snap Rings and Flywheels

1. Use snap ring pliers to remove the snap rings (5) on either

end of the pinion. Set the rings aside.

2. Use a 4mm Allen wrench to loosen the set screws (6)

located in the center of the flywheels around the pinion.

Remove tension off the keyway tabs (8) but, it is not

necessary to remove the screws.

3. Use a 3lb hammer to knock the flywheels (7) off of the pinion.

Tap the flywheel’s outer edge and rotate the wheel every couple

hits. Set the flywheels aside.

STEP 3: Remove the Keyway Tabs and Bearing Plate

1. Use a pair of pliers or a chisel on the outside edge of the

keyway tab (8) and remove them with a hammer. Set the tabs

aside.

2. Use a 14mm wrench to remove the three bolts holding the

bearing plate (9). A 12mm wrench may be needed to hold the

bolt heads. Remove the one bearing plate and set it aside.

3. Replace the three nuts to prevent the bolts from backing out.