Installation Guide

2023.03.08

12. Apply Loctite PL Premium construction adhesive

to all surfaces of the bench frame which are in contact

with the Redi Bench when it is placed in the frame

(i.e., the top of the frame and the vertical frame studs

above the splash wall.) Then, install the Redi Bench

by securely placing the Redi Bench on the framing

so it is in contact with all the seat and leg support

areas containing Loctite PL Premium construction

adhesive. Press the Redi Bench firmly onto the Loctite

PL Premium construction adhesive on the bench

frame and hold it securely in place for approximately

30 minutes. After placing the bench frame wipe clean

any excess silicone.

13. Install the Redi Flash on the top of the 3 splash

walls of the Redi Bench in the same fashion that the

Redi Flash was installed on the shower base splash

walls.

14. Install the shower backer board and waterproofing

in accordance with the standards established by

the Tile Council of North America, Inc. Seal and

waterproof joint between backer board and the

shower pan splash walls using Redi Flash® or 100%

silicone. It is recommended to use a membrane and

fluid applied waterproof in addition to the Redi Flash®

or 100% silicone.