Installation Guide

2022.06.16
11. Adjust the height of the drain as necessary to accommodate the
flooring covering. Set your tile using a white modified thin-set and a
notched trowel as specified by your thin-set manufacturer based on your
tile size. Tile Redi recommends the modified thin-set products found in
table below.
Tile the rest of the shower.
Tile Redi Approved Modified Thin-sets
MAPEI Ultraflex LHT White
MAPEI Large Format Floor and Wall
White
CBP Prolite White
MAPEI Ultraflex 1 White MAPEI Porcelain Tile White CBP Flexbond White
MAPEI Large Tile and Stone White
MAPEI Ultraflex LFT White
TEC Ultimate 6 Plus 487 White
436 East 36th Street, Charlotte, NC 28205
800.232.6156 | [e-mail]
www.tileredi.com
Tile Redi® trademarks and logos are owned by and the Intellectual Property of Tile Redi, LLC.
©2022 Tile Redi, LLC. All Rights Reserved.
PATENT: www.TileRedi.com/PatentMarkings
10. Install the shower backer board and water proofing in accordance
with the standards established by the Tile Council of North America, Inc.
Seal and waterproof joint between backer board and the shower pan
splash walls using Redi Flash® or 100% silicone. It is recommended to use
a membrane and fluid applied waterproof in addition to the Redi Flash®
or 100% silicone. Allow the mortar bed to dry in accordance with the
instructions of mortar manufacturer.