Use and Care Manual

TIKI
®
BRAND FIRE RING USER GUIDE
6 7
C
Remove the ash pan (F) and dome insert (C)
from the Fire Pit (A) and set aside.
STEP 1
Place the Fire Pit (A) on top of the foot ring (B)
ensuring the 3 tabs on the foot ring align with
the 3 holes at the base of the Fire Pit and secure
with 3 screws (H) using the supplied Hex Key.
STEP 3
Separate the Fire Pit (A) from the foot ring (B)
and place the foot ring on its feet.
STEP 2
Replace the ash pan (F) and dome
insert (C) back into the Fire Pit.
STEP 4
Assembly Light your Fire Pit
CAUTION: Some parts may contain sharp edges. Wear protective gloves when assembling, moving,
or handling product.
You can use TIKI
®
Brand Wood
Packs (sold separately) (see page 8)
or natural cut firewood (see below)
to light your fire.
B
A
H
B
A
F
C
OR
F
A
C
• Flip over the center dome insert (C) and place back into the Fire Pit. This will
increase airflow and make more room for the firewood to sit below the rim of
the fire pit. This will help reduce smoke.
• Stack kindling, newspaper, a commercially-available fire starter or TIKI
®
Brand
Fire Starter, in the center of the Fire Pit.
• Build larger pieces of wood around the fire starter.
• Ignite the kindling, newspaper, or fire starter with a match. Use with caution
as these ignitable materials could catch fire quickly and could cause burns if
your hand is too close to the fire.
• DO NOT use lighter fluid to light the natural cut wood. Logs should be less
than 16 in. in length. DO NOT use any flammable fluids (gasoline, lighter fluid,
etc.) to light or relight fires. Doing so could cause serious injury and lead to
the fire getting out of control.
Light your Fire Pit
using natural cut rewood
VS
NOTE: Not shown to actual
scale or size.
CAUTION: Keep clothing, hair and face
away from flame when lighting.