User's Guide

Page 8 of 8

CONFIDENTIAL

TigoRFcore User Guide

4.5 Limited Modular Approval

The requirement for KDB 996369 D03:

List of applicable FCC rules

FCC CFR Title 47 Part 15 Subpart C Section 15.247

Summarize the specific operational use conditions

This module has been granted Limited Modular Approval for mobile applications. OEM integrators for host

products may use the module in their final products without additional FCC certifications if they meet the

following conditions. Otherwise, additional FCC approvals must be obtained.

• The host product with the module installed must be evaluated for simultaneous transmission

requirements.

• The user’s manual for the host product must clearly indicate the operating requirements and

conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.

• To comply with FCC regulations limiting both maximum RF output power and human exposure to RF

radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not

exceed: https://www.inventeksys.com/2-4ghz-antenna-sma/

• A label must be affixed to the outside of the host product with the following statement:

This device contains FCC ID: 2ATSM-TGRFCM1

The final host / module combinations may also need to be evaluated against the FCC Part 15B criteria for

unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.

Information on test modes and additional testing requirements

Date transfer module demo board can control the EUT work in RF test mode at specified test channel.

Additional testing, Part 15 Subpart B disclaimer

The module without unintentional-radiator digital circuit, so the module does not required an evaluation

by FCC Part 15 Subpart B. The host should be evaluated by the FCC Subpart B.

Limited module procedures

The module has not its own antenna, the host meets the necessary requirements to satisfy the

module limiting conditions.

Trace antenna designs

Not applicable.

RF exposure considerations

The host device manufacturer should confirm that a separation distance of 20 cm or more should be

maintained between the antenna of this host device and persons during the host device operation.

Antennas

The device itself has no antenna, customer can use the PCB antenna, Ceramic antenna or FPC antenna

with antenna gain isn't greater than 2.15dBi.

Label and compliance information

If this certified module is installed inside the host device, then the outside of the host must be labeled with

“ Contains FCC ID: 2ATSM-TGRFCM1”.