User's Manual

TigoMaster 2TH User Manual

Page 17 of 36

CONFIDENTIAL

Mounting and demounting

2.1 Mounting

Required tools for mounting the device

You will need the following tools for mounting:

- Allen key for the M4 fixing screws with hexagon socket

Only additionally required for installation without existing threaded hole:

- M4 thread tap (readymade or set of taps)

- Drilling machine (to pre-drill the mounting holes for the device for mounting on the system)

You will also need two M4 hexagon socket head screws according to DIN 912 / ISO 4762 of suitable

length.

Before mounting the device

Always observe the following instructions:

- The device may only be installed and commissioned by qualified electricians in accordance with EN

50110-1/-2 and IEC 60364.

- Refer to the safety instructions in the Safety [} page 11] chapter.

- Before mounting the device, check for damage, e.g. transport damage! Damaged devices must not be

put into operation.

Mounting instructions

Observe the following points when selecting the mounting location:

- When mounting outside buildings: Mount the device in such a way that it is protected from

weathering, especially from direct sunlight and the effects of UV light, salt water or salt spray, e.g. in

a switch box.

- Only screw the device on flat contact surfaces to protect it from mechanical tension.

- Do not bridge any gaps with the unit to protect it from any tensile forces that may occur.

- To prevent damage to the unit, do not mount it in shearing areas of moving system parts. Also, lay

the cables in such a way that they cannot be caught in the shear zones of moving system parts.

- Leave sufficient space for easy replacement of the unit and for connecting the plug connections.