installation Manual

RSS TRANSMITTER COMMERCIAL INSTALLATION
Note: Install TS4-F before powering on RSS Transmitter
· Mount RSS Transmitter and power supply on DIN rail
· Connect DC leads from power supply (1) to transmitter (2)
· Connect RSS Core (3) and (4) to transmitter
Place rapid shutdown system label no more than 1m (3ft) from RSS Transmitter
or AC disconnect if not at same location.
3
4
1
2
Rapid
Shutdown
System
Transmitter
NN
LL
-
+
1 DIN Rail PSU
200-500V
AC
Power Supply
2 RSS Transmitter
3
4
RSS Core (CT)
RSS Core (CT)
Ground
Neutral
LED (Power)
+12V
DC
+V
IN
-12V
DC
GND
+ V ADJ
+V
G L2 L1
-V
1 2
3
4
RSS Core inputs
RSS Core inputs
LED (Signal)
Transmitter power supply must be on same AC branch circuit as inverter to meet rapid shutdown requirements.
Rapid
Shutdown
System
Transmitter
No Connection
19