installation Manual

RSS TRANSMITTER INSTALLATION –
DUAL RSS CORE
Note: Install TS4-F before powering on RSS Transmitter
· Drill holes in enclosure for conduit (see drilling guide for placement)
· Mount RSS Transmitter and power supply on DIN rail
· Connect DC leads from power supply (1) to transmitter (2)
· Connect RSS Core (3) and (4) to transmitter
Place rapid shutdown system label no more than 1m (3ft) from RSS Transmitter
or AC disconnect if not at same location.
3 4
1 2
Rapid
Shutdown
System
Transmitter
NN
LL
- +
1 DIN Rail PSU
2 RSS Transmitter
3
4
RSS Core (CT)
RSS Core (CT)
LED (Power)
+V
IN
GND
RSS Core inputs
RSS Core inputs
LED (Signal)
1 2
3
4
Transmitter power supply must be on same AC branch circuit as inverter to meet rapid shutdown requirements.
LOCK OUT
TAG OUT
Rapid
Shutdown
System
Transmitter
RSS Core
polarity marking
Match RSS Core polarity
to ensure PLC signal ow
in the correct direction.
No Connection
16