User Manual

[e-mail]
8
* Accessories are available for purchase separately at amazon.com/tigersecu
* This step is required for all the models.
A) Prepare the DVR, Camera, Cable, Power Supply, (Power Splitter).
B) Plug the (camera only) BNC connector and power cable into the camera.
Twist and lock the end of the BNC cable to secure the connection.
C) Connect the cameras using BNC cables to the back of the DVR, as shown in
the pictures.
D) Plug the DVR power supply cord into the DC port on the back of the DVR. Plug
female end of the BNC cable into the cameras power supply.
* Repeat the steps A to C for each camera. You may also use the power splitter
so you will need fewer power supplies.
4. Connect the DVR with the Router
* Router and network cable are not included in the package.
* If you only want to view the DVR locally on the monitor, please skip this step.
Prepare the DVR, router and network cable. Connect them as shown above.
5. Complete the Setup
A) Power on the DVR, the monitor and the cameras.
B) Connect the mouse to the USB slot on the DVR back panel.
C) You will see TIGERSECU LOGO in a few seconds, then the Live View Screen and
the Start-up wizard which will guide you through the basic settings.
D) Check Chapter 2, 3 if you want to explore all the features of the DVR.
Check Chapter 4 (Page 32) if you want to check the DVR on your phone.
Check Chapter 5 (Page 37) if you want to view the DVR on the computer.
Installation Guide