Instruction Manual

Operating Instructions
10409 — Gunite/Brunner/Bendix Slack Adjuster Puller
NOTE: Threads must be clean and well lubricated at all times. Do not use over a 1⁄2" impact wrench—doing so will void warranty.
Hammering this tool will void your warranty.
Using the 10409
1
Remove clevis pin from the end of the slack adjuster with the Tiger Tool 10501 Brake Clevis Pin Press. Remove the slack
adjuster rod from the slack adjuster with the Tiger Tool 10502 Slack Adjuster Rod Pin Press.
2
Back out the forcing screw, slip the puller onto the slack adjuster. Align the tip of the forcing screw with the center of the s-cam.
3 Attach the tool to the slack adjuster through the clevis hole using the supplied hardware.
4 Turn the forcing screw by hand or with an impact wrench.
5 Hold the puller and slack adjuster to keep it from falling to the ground.
Operating Instructions
10410 — Haldex Multi Adjustable Slack Adjuster Puller
NOTE: Threads must be clean and well lubricated at all times. Do not use over a 1⁄2" impact wrench—doing so will void warranty.
Hammering this tool will void your warranty.
Using the 10410
1
Remove clevis pin from the end of the slack adjuster with the Tiger Tool 10501 Brake Clevis Pin Press. Remove the slack
adjuster rod from the slack adjuster with the Tiger Tool 10502 Slack Adjuster Rod Pin Press.
2
Select the bent or straight arm and attach to the main puller body with the 1⁄2" x 1" bolt supplied. Do not tighten at this time.
Note: straight arm is for older style Haldex slacks. The bent arm is for newer angled and/or offset Haldex slack adjusters.
3
Back out the forcing screw, slip the puller onto the slack adjuster. Align the tip of the forcing screw with the center of the s-cam.
4
Secure the selected arm to the slack adjuster through the clevis hole using supplied 1⁄2" x 2 1⁄2" hardware.
5 Tighten 1⁄2" x 1" and 1⁄2" x 2 1⁄2" bolts to securely mount the puller to the slack adjuster.
6 Turn the forcing screw by hand or with an impact wrench.
7 Hold the puller and slack adjuster to keep it from falling to the ground.
Operating Instructions
10501 — Brake Clevis Pin Press
NOTE: Threads must be clean and well lubricated at all times. Do not use over a 1/2" impact wrench
doing so will void warranty.
Using the 10501
1
Back out the forcing screw.
2
Pull back the spring-loaded plunger and slip the tool over the clevis pin.
3
Turn forcing screw by hand or with an impact wrench; the tool will shear the cotter pin.
4
Once the pin is free of the clevis, back out the forcing screw and remove the tool.
View the Slack Adjuster Rod Pin Press demonstration video online at tigertool.com
VIDEO
INSTRUCTIONS