Instruction Manual

Operating Instructions
Using the 10406
1 Using the appropriate Tiger Tool Tie Rod End Remover, separate the tie rod from the spindle, drag link, etc.
2 Install Tie Rod Socket onto end of impact or hand wrench.
3 Establish thread direction needed for removal.
4 Begin to supply power to Tie Rod Socket. The tie rod should now spin off the rod. Note: If for any reason the tie rod end does
not move easily off the rod, stop supplying power to the tool and apply a penetrating lubricant to the threads of the part to be
removed. Wait a few minutes and try the tool again.
10406 — Manual Slack Adjuster Puller
View the Manual Slack Adjuster Puller demonstration video online at tigertool.com
VIDEO
INSTRUCTIONS
NOTE: Threads must be clean and well lubricated at all times. Do not use over 1⁄2" impact wrench. Doing so
will void warranty. Hammering this tool will void your warranty.
Operating Instructions
Using the 10407
1 Remove clevis pin from the end of the slack adjuster with the Tiger Tool 10501 Brake Clevis Pin Press. Remove the slack
adjuster rod from the slack adjuster with the Tiger Tool 10502 Slack Adjuster Rod Pin Press.
2 Back out the forcing screw. Slip the puller onto the Slack Adjuster. Align the tip of the forcing screw with the center of the s-cam.
3 Attach the tool to the slack adjuster through the clevis hole using the supplied hardware.
4 Turn the forcing screw by hand or with an impact wrench.
5 Hold the puller and slack adjuster to keep it from falling to the ground.
10407 — Rockwell Slack Adjuster Puller
View the Rockwell Slack Adjuster Puller demonstration video online at tigertool.com
VIDEO
INSTRUCTIONS
NOTE: Threads must be clean and well lubricated at all times. Do not use over 1⁄2" impact wrench.
Doing so will void warranty. Hammering this tool will void your warranty.